Search    Home | Register | Login | Join | Trade | Forum | Cart

  < Back

     ChengGong Entity Group Co., Ltd. 

     About this company : our is export-oriented company in shenzhen of China. we have been handling in export of cisco network products for nearly 10 years. our products include mainly cisco switch, cables routers, transceiver, router module, wan interface card,network adapter, firewall and LCD panels ect. or products are good quality at compritive prices popular with our regular and new customers. we have been doing business on the prindiple of equality and mutual benefit. we honestly hope to hear from any of possible customers. please contact me for more details or login to MarginUp to trade with us instantly.

     Contact : yueshan wang, foreign trade manager 
     Headquarters : Tai Bao Road Fu Tian, shenzhen, GuangDong, 518000, China
     Phone : 0086075526972059, Fax : 0086075526972059 
     Website : Log on to trade instantly , Email : Log on to trade instantly

     cisco cab cisco cab CAB-V35MT

Male DTE V35 CAB, 10FT (p/n 72-0791-01)
  > Add to cart

     cisco router cisco router router1721

10/100 Module Router w/2 WAN slots (new)
  > Add to cart

     cisco switch cisco switch ws-x4148

Key Features:

Data transfer rate: 100Mbps
Form factor: plug-in module
Cabling type: Ethernet 100-Base-Tx. Ethernet10Base-TOther
Features: Data link protocol: Ethernet. Fast Ethernet.
Miscellaneous: MPN: Ws-x4148-RJ

  > Add to cart

     cisco switch cisco switch ws-x4306GB

Key Features:

Type: Ethernet
SwithchInterfaces: Ports:6*GB
ICStandards and Protocols: LAN
Standards: IEEE802.3ab 1000Mbps (Gigabit Ethernet). IEEE802.3z Gigabit Ethernet over fiber standard.(1000Basex)
Miscellaneous: MPN: Ws-x4360-GB

  > Add to cart

     cisco switch cisco switch ws-c2950-24

Key Features:

Type: Ethernet SwitchOSL Layer;
layer2Managed Device: Managed
InterfacesInterfaces: Ports:24*10Base-T/100Base-TX(RJ-45)
Consol port type: serial(RJ-45)
Performance: Switch
FabricCapacity: 4.8GbsLayer2
Forwarding Rate: 3.6MbpsMAC
Address Entries: 8000Standards and Protocols: LAN
Standards: IEEE802.1d Spanning Tree Bridge. IEEE802.1Q Virtual LANS (VLAN). IEEE802.3cSMA/CD or Ethernet. IEEE802.3u100Mbps(Fast Etnernet)
Remote Management Protocol: SNMPProtocols: IP. Radius.tftp
Other Features: LED
Indicators: Link/status. Full. Duplex/Half Duplex. Power.Speed

  > Add to cart

     LCD panel LCD panel 32 inch LCD panel

32" LCD panel
  > Add to cart

     router module router module wic-1t

1)One serial port.

2)Uses the Cisco 60-pin "5-in-1" connector. This connector is DB-60 on one end and can be V.35, RS-232, RS-449, X.21 or EIE-530 on the other end depending on your needs

3)Uses the same cabling as Cisco 2500 and Cisco 7000 serial ports.

4)Does not support hot swap, however no hardware damage will occur if it is swapped while the power is on.

5)Each serial card has one LED, labeled CONN for each port, which lights when the serial port is connected. When the port is in data terminal equipment (DTE) mode, the CONN LED indicates that Data Set Ready (DSR), Data Carrier Detect (DCD), and Clear To Send (CTS) have been detected. When the port is in data communications equipment (DCE) mode, it indicates that Data Terminal Ready (DTR) and Request To Send (RTS) have been detected

  > Add to cart

     router module router module wic-2t

The WIC-2T provides two serial ports using the Smart Serial connector.

Asynchronous support with a maximum speed (per port) of 115.2 Kbps, minimum 600 bps. If you need to run at speeds lower than 600 bps, use the AUX port instead.

Synchronous support with a maximum speed of 8 Mbps per port.

Supports one port at 8 Mbps when used in NM-1FE1R2W, NM-1FE2W, NM-2FE2W, or NM-2W, or Cisco 2600 chassis WIC slots. All other WIC ports on that network module or Cisco 2600 chassis must not be used.

Supports two ports at 4 Mbps each when used in NM-1FE1R2W, NM-1FE2W, NM-2FE2W, or NM-2W, or Cisco 2600 chassis WIC slots. All other WIC ports on that network module or Cisco 2600 chassis must not be used.

Supports 8 Mbps on all ports simultaneously on 2691, 3725, and 3745. No restrictions. Maximum six ports at 8 Mbps each

  > Add to cart

     transceiver transceiver ws-G5486

WS-G5486 FluxLight Brand Cisco Compatible 1000Base-LX GBIC Transceiver
  > Add to cart

     transceiver transceiver GLC-LH-SM

The Cisco industry-standard Small Form-factor Pluggable (SFP) Gigabit Interface Converter is a hot-swappable input/output device that plugs into a Gigabit Ethernet port or slot, linking the port with the network. SFPs can be used and interchanged on a wide variety of Cisco products and can be intermixed in combinations of 1000BASE-SX, 1000BASE-LX/LH, or 1000BASE-ZX on a port-by-port basis.
  > Add to cart

Page 1 of 1
  ^ Back to top

   Bookmark and Share

About Us | Register | Login | Join | Trade | Forum | Cart |  Join  |  Connect  |  Follow
Know-How | Trading Precaution | Phishing Alerts | SOAOnDemand! | VAR 360 | RSS Feed 

  Copyright © 2024 MarginUp All Rights Reserved.
MarginUp User Agreement and Privacy Policy.